I tried this out last night and had different results. I was able to tune
with no problem with both or either NB or NR selected. But, I did notice
that if I selected say NR and then changed the value to something else say
4 instead of 5, then I had to click another button (or the NR button)
I observe this pause too. The main VFO does not move while the NR or NB setting
display is showing. I am not sure if this was always like this or not.
Perhaps someone with an earlier version of firmware would like to check and
comment?
73
David Anderson GM4JJJ
On 2 Jan 2015, at 08:07,
Thanks for clarifying that. It's not something that had bothered me, but I just
observed it after Nakamura asked the question about the behaviour of the VFO
with NB/NR. I had thought at first he meant it stopped the VFO completely, not
just a short pause while displaying the parameters - which
When you're displaying noise blanker or or noise reduction parameters, etc.,
the VFO is disabled.
Wayne
N6KR
http://www.elecraft.com
On Jan 3, 2015, at 1:11 AM, David Anderson gm4...@yahoo.co.uk wrote:
I observe this pause too. The main VFO does not move while the NR or NB
setting
Hi Brian / VE3IBW, David / GM4JJJ
While setting PBT I/II , I was able to tune the main knob.
As with this, While setting NR/NB, I should be able to tune the main knob.
#Turning the PBT knob in NR/NB setting, PBT settings are changed(set and
exit NR/NB).
#If the same as this manner, I should be
Hi all, Happy New Year 2015!
In version 2.27, when you turn on the NR or NB of KX3, will not move the
main dial.
Is this a specification, or bug of v2.27?
---
JE0LFI / Nakamura
--
View this message in context:
http://elecraft.365791.n2.nabble.com/KX3-MCU-2-27-BUG-NB-NR-mode-tp7596662.html
6 matches
Mail list logo
