Is there a template for configuring N1MM+ to use with a K3s so that I
can record TX audio on the fly using the Function keys?
Asking for a friend as I don't (yet) own a K3s, but I know his has
direct USB connection to the PC so I'm not sure where to start in
configuring N1MM+ and the K3s.
] On Behalf Of Keith
Robinson
Sent: mercoledì, 5. agosto 2015 23:21
To: elecraft@mailman.qth.net
Subject: [Elecraft] TX Audio
To all the new K3S owners,
I need a little help with an issue I am having with my K3S so I thought I would
ask for some input.
The issue is with audio being sent from the PC
To all the new K3S owners,
I need a little help with an issue I am having with my K3S so I thought
I would ask for some input.
The issue is with audio being sent from the PC to radio thru the USB cable.
Simply put, I have non. Receive audio going back to the PC
from the radio is fine. The S
Be sure the 3.5mm LINE IN jack has nothing plugged in. if a cable is
plugged into this jack, the KIO3B will only accept LINE audio from the
jack, not from the USB.
LINE OUT will always be active on both the analog 3.5mm jack as well as USB.
73,
Lyle KK7P
On 8/5/15 2:21 PM, Keith Robinson
Sri, I accidently sent the last unfinished letter.
I presume the third -order intermodulation {IMD} should suggest the answer.
Here i see that the Ft5000 is better than the K3, but only when the FT5000
is using class A modulation. One should expect lower IMD running Class A ,
right?
Larry,
IMO, it's difficult to properly set up the TX audio ... especially
the equalizer ... by listening to yourself. I have a long-time friend
who has a Flex that's helped me set up the TX's audio by guiding
me while watching my signal's audio on the Flex display.
73! Ken - K0PP
I use my Perseus SDR to record the whole band while transmitting with my
K3 into a 50 Ohm load. For those not familiar with the Perseus, it can
record up to 1600 KHz of frequency to hard disk for later playback as if
you were listening to a live transmission.
I save the file with an appropriate
For the ones who might be interested,I have created 6 MP3 audio files testing
in my K3 the following mics:
Kenwood MC-43S
Elecraft MH-2
Audio Tecnica ATR-30
On these clips you will be able to hear the difference between them with
ragchewing or dx/contesing audio,also I included a word document
I saw a note from Lyle that indicated that the TX audio passband was
250hz to 3150hz. Would this be any different with the 6khz roofing
filter( ESSB enabled) or is it a firmware issue at this time?
Jay - KT5E
___
Elecraft mailing list
Post to:
When ESSB is enabled in FW it should be different, but not till then.
73
Greg
AB7R
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Jay Schwisow
Sent: Wednesday, January 30, 2008 5:59 PM
To: Elecraft Discussion List
Subject: [Elecraft] TX audio passband
10 matches
Mail list logo
