[EMAIL PROTECTED] wrote:
In a message dated 18/03/05 17:35:05 GMT Standard Time, [EMAIL PROTECTED]
writes:
Thanks for all the help on my blank display problem. I've followed
everybody's suggestions. I even resoldered every point.
Roland,
Check that you have soldered pin 1 on U1,
R Kevin Stover wrote:
...If some of you will recall, I picked this up with the front board and
control board complete. I carefully (or so I thought) retraced every step
in the manual and am up to phase 1 of the testing and calibration...
-
Was the MCU (U6) installed in that
In a message dated 18/03/05 19:27:35 GMT Standard Time, [EMAIL PROTECTED]
writes:
I should have added if it wasn't clear that you need to remove U1 before
trying the heated socket procedure.
---
Think I must have removed the chip
3 matches
Mail list logo
