[EMAIL PROTECTED] wrote:
In a message dated 18/03/05 17:35:05 GMT Standard Time, [EMAIL PROTECTED]
writes:
Thanks for all the help on my blank display problem. I've followed
everybody's suggestions. I even resoldered every point.
Roland,
Check that you have soldered pin 1 on U1, the display driver on the front
panel board. A common mistake is missing this soldered joint. I made the same
mistake and it can be seen without removing the display. Fixed mine without
removing the display, though does need a steady hand.
Bob, G3VVT
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
I should have added if it wasn't clear that you need to remove U1 before
trying the heated socket procedure.
--
R. Kevin Stover ACØH
K2/100 #4684
Reclaim Your Inbox!
http://www.mozilla.org/products/thunderbird
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
