On Wed, 20 May 2020 at 03:29, Reinhard wrote:
> ... and from tool table: tool 21 is in slot 5 and tool 30 is in slot 21.
> Neither tool 21 nor tool 31 are mentioned in gcode file, so a random
> toolchanger can't use these slots for whatever reason.
I noticed that the status in Touchy was
Hi Stuart,
thank you for your attention!
On Dienstag, 19. Mai 2020, 17:42:39 CEST Stuart Stevenson wrote:
> The stop spindle command on line 20 seems correct to me as stopping and
> starting the spindle should be part of the total tool change routine and
> come between the start change and end
The stop spindle command on line 20 seems correct to me as stopping and
starting the spindle should be part of the total tool change routine and
come between the start change and end change commands.
As for the 21 and 5 commands I can only guess. It is possible the 21 and 5
are pocket numbers to
Hi,
I digged a bit deeper to understand what happens, but result is, the deeper I
dig, the less I understand.
I added N-words to each line to be able to link (in my mind) interpreter
output to each gcode-line.
Sample is now like this (obvious motion lines ommited):
N005 G17 G21 G64
( Tasche1
