Hi Jan.
Mechanics of an axis Y in a good condition. Plugs are a little melted off. The
powersupply to the Y-axis has its own powersupply.
Thanks a lot ,Andrey
--
Download new Adobe(R) Flash(R) Builder(TM) 4
The new
Schweet! What else do you have left to do Sam?
Mark
At 09:44 AM 10/17/2010, you wrote:
I think we have the spindle/tool change working well. Next is
pallet change and B axis. This video shows it find the tool - rapid
to the g30 home tool change position - then spindle orient and then
I still have to really tune all the axis. (velocity mode amps seem to
be pretty forgiving - all I did so far was calculate the output scale
and adjust the following error at a slow ipm by adjusting the amps loop
gain.) (P=20 D=1 FF1 =1)
We need to get something hooked in for the B axis. I
sam sokolik wrote:
I still have to really tune all the axis. (velocity mode amps seem to
be pretty forgiving - all I did so far was calculate the output scale
and adjust the following error at a slow ipm by adjusting the amps loop
gain.) (P=20 D=1 FF1 =1)
If you haven't done serious
Is anybody out there using Martin Schoeneck's Eagle2HAL configuration
program?
http://wiki.linuxcnc.org/emcinfo.pl?Eagle2HAL
I'm writing up my Logitech gamepad Joggy Thing for Digital Machinist and
realized that it's *much* easier to talk about circuit diagrams than
lines of HAL code. I
