. Make me think of Eric
Clapton - I must be invisible :)
On 2014-04-06 16:21, andy pugh wrote:
On 6 April 2014 14:14, Bill Brettle billbret...@gmail.com wrote:
I've worked hard at my .ini and Hal but can't get rid of that error.
The problem is still there and still the same cause.
You
Heskett ghesk...@wdtv.com wrote:
On Sunday 06 April 2014 03:38:15 Bill Brettle did opine:
Thankyou both
First, the LOW on pin 1 was 0v sorry to muddy the waters.
Second, I corrected the -out-invert problem now I get this Error
message Debug file information:
Can not find -sec MOT -var
sure that I'm not making a complete mash of them.
Regards Bill
On Wed, Apr 2, 2014 at 7:46 PM, andy pugh bodge...@gmail.com wrote:
On 2 April 2014 05:51, Bill Brettle billbret...@gmail.com wrote:
1. how is Xenable triggered, it doesn't appear to be going high
Xenable isn't a HAL pin, so
in my .ini?
Hope I'm making sense
Regards Bill
PS Gene, Hows the back going, any news on the op.? B
On Sat, Apr 5, 2014 at 11:51 PM, Gene Heskett ghesk...@wdtv.com wrote:
On Saturday 05 April 2014 09:28:28 Bill Brettle did opine:
Hi again everyone
Pin No. 01 on my BOB is enable
screen.
On 2014-03-29 05:41, Bill Brettle wrote:
My Mill would not connect and I received a fairly long message entitled
LinuxCNC Errors which stated in the header When reporting
problems,please include all the information below in your message.
However, I cannot copy, print
My Mill would not connect and I received a fairly long message entitled
LinuxCNC Errors which stated in the header When reporting
problems,please include all the information below in your message.
However, I cannot copy, print, or in any other may transmit this
information.
