Sorry Marius, I did read your message and I thought I had tried it together with a multitude of other configs, but I must have either missed it put a typo in the line somewhere, anyhow, my sincere apologies.
I thought I had it then I found I had some wiring problems (as Gene said)(LM7805 and LM7905 are different). Between fixing these and helping look after my 5yr old Grandson who is on school vacation, I haven't achieved much. Yesterday I finally got LCNC connected to my mill and immediately received messages *"joint 0 limit switch X".* I googled this and found that the problem was BOUNCE and I needed to run a "debounce" commands. I found two methods (see "debounce" file). The first was to be included in custom.hal which I did and received an error message "parport.0.pin-10-in already exists" I deleted this and added the second method to BillsMill.hal this time I got the LINUXCNC ERROR attached. Now I'm bushed, Where do I go from here? Incidentally, what to I do with the other items in the Debug file information? Sorry to be such a pest. Regards Bill On Mon, Apr 7, 2014 at 12:27 AM, Marius Liebenberg <mar...@mastercut.co.za>wrote: > I thought that was exactly what I explained. Make me think of Eric > Clapton - I must be invisible :) > > On 2014-04-06 16:21, andy pugh wrote: > > On 6 April 2014 14:14, Bill Brettle <billbret...@gmail.com> wrote: > > > >> I've worked hard at my .ini and Hal but can't get rid of that error. > > The problem is still there and still the same cause. > > > > You have: > > setp parport.0.pin-01-out-invert > > > > You should have: > > setp parport.0.pin-01-out-invert 1 > > > > or, if you prefer: > > setp parport.0.pin-01-out-invert true > > > > "setp takes two arguments" means that a setp command needs to know > > which pin to set _and_ what value to set it to. > > > > -- > > Regards /Groete > > Marius D. Liebenberg > +27 82 698 3251 > +27 12 743 6064 > QQ 1767394877 > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users >
BillsMill.hal
Description: Binary data
linuxcnc
Description: Binary data
debounce
Description: Binary data
------------------------------------------------------------------------------ Put Bad Developers to Shame Dominate Development with Jenkins Continuous Integration Continuously Automate Build, Test & Deployment Start a new project now. Try Jenkins in the cloud. http://p.sf.net/sfu/13600_Cloudbees
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
