Nicklas,
i think i presume too much edm experience, sorry
for positioning, most edm systems use a low power sensing circuit
really low, like 12 V at 100ma is plenty
if you are positioning, this low power sense circuit is always in operation
if you are cutting, the spark generator is in operation
> "halcmd show pin" will tell you which pins actually exist.
Yes it does.
> Is it possible that the HAL is trying to connect pins before they
> exist?
Then i copied the row from "halcmd show pin" it worked. Problem is manual claim
it should be gladevcp.speedcontrol1-value while in reality it
> Merry Christmas to all
>
> Iam presuming we could use the probe sequencing as a way to find centre of
> a hole , or find an edge
> in the same way as a mill , just inhibit any power or in the case of a wire
> keep it stationary
The sparc generator have the potential to sense the voltage and I
"halcmd show pin" will tell you which pins actually exist.
Is it possible that the HAL is trying to connect pins before they
exist? With embedded tabs it is best to connect them up with a HAL
file loaded by the -H option:
http://linuxcnc.org/docs/2.7/html/man/man1/gladevcp.1.html
On 23/12/2016,
> > Only problem I have so far
> > is to get numeric values from SpeedControl widget, it complain it can't find
> > the pin.
>
> Glade controls tend to have two HAL pins, gladevcp.pin-s and
> fladevcp.pin-f which are the value as a signed int and as a float.
> Perhaps you have omitted to -s or
On 22/12/2016, Nicklas Karlsson wrote:
> Only problem I have so far
> is to get numeric values from SpeedControl widget, it complain it can't find
> the pin.
Glade controls tend to have two HAL pins, gladevcp.pin-s and
fladevcp.pin-f which are the value as a signed
Sarah Hello
On 12/23/16 18:24, Sarah Armstrong wrote:
> Merry Christmas to all
>
> Iam presuming we could use the probe sequencing as a way to find centre of
> a hole , or find an edge
> in the same way as a mill , just inhibit any power or in the case of a wire
> keep it stationary
edm
Possibility to use the same is why I asked. TJ Powderly proposed some, I
have manual for Sodick wire EDM and Charmilles ordinary EDM at home. I have
never used an EDM machine but work profesionally with software development.
2016-12-23 12:24 GMT+01:00 Sarah Armstrong
Merry Christmas to all
Iam presuming we could use the probe sequencing as a way to find centre of
a hole , or find an edge
in the same way as a mill , just inhibit any power or in the case of a wire
keep it stationary
is their any edm machines actually using gcode / m codes? perhaps we can
use
I will look for the mcodes you uploaded. With g-codes I more or less
thought about all the different letters although which letter to use is
rather important.
2016-12-23 3:29 GMT+01:00 TJoseph Powderly :
> Merry Christmas Nicklas
>
> On 12/23/16 05:12, Nicklas Karlsson wrote:
>
10 matches
Mail list logo