indeen! Spiral out from center going as deep as possible and constand
radial engagement. When that is exhausted them
try same idea on the triangular remanents. Then go back and test that
against Jon Elson's code. Machining is an experimental science. Eh?
Dave
On 9/18/22 12:18 PM, Nicklas SB
I was not thinking to much about the corner. If machining with for
example 50% tool engagement then end is reached machining at 90 degrees
into material and tool engagement increase to 100% before next pass. An
alternative would for example be to machine into material with an angle.
For the
Hi Nicklas,
Just a WAG, offset cutter maybe .25 mm from real corner and plunge then
clean up in incrementally with a couple of passes to clean out the
wings. I think most cam programs just take light passes including the
finish pass.
How stiff the spindle is and sharpness of the cutter are
When using an adaptive/high speed machining tool path, make sure that the
minimum radius for movement of the tool is a reasonable number (10% or more of
the tool dia.).
When doing the final clearing pass you can also use plunge roughing at the
corners if you cannot go to a significantly
Le sam. 10 sept. 2022 à 11:55, Nicklas SB Karlsson a écrit :
> Then pocket milling with tool engagement less than tool diameter for
> some patterns tool engagement increase to tool diameter in the corners
> or ends. Anybody have anyone have any experience or knowledge how to
> handle this
Then pocket milling with tool engagement less than tool diameter for
some patterns tool engagement increase to tool diameter in the corners
or ends. Anybody have anyone have any experience or knowledge how to
handle this situation?
Nicklas Krlsson
