On 3/19/2024 7:13 PM, Jay Summet via EV wrote:
In my leaf pack I had a 3 Parallel x 16 Series battery pack.
I tied each of the 3 "sense" center posts together for each set of 3
cells. [The only thing these tied together center posts were connected
to was my BMSbut I did tie the 3 center
He is talking about the Solectria E10. The S10 conversion.
On Tue, Mar 19, 2024 at 7:45 PM Cor van de Water via EV
wrote:
> Yep, best to use a (thin) conductor to tie all 3 center posts together
> and the cell level BMS.
> Although I have seen people chance it, depend on the low voltage
>
Yep, best to use a (thin) conductor to tie all 3 center posts together
and the cell level BMS.
Although I have seen people chance it, depend on the low voltage
cut-off of the load and the max voltage setting on the charger and
hope the modules stay in balance...
On Tue, Mar 19, 2024 at 7:13 PM
On 3/18/24 18:37, John Lussmyer via EV wrote:
Note: You really do NOT need to tie the center posts to anything other
than a BMS. Even with cells in parallel.
In my leaf pack I had a 3 Parallel x 16 Series battery pack.
I tied each of the 3 "sense" center posts together for each set of 3
Is your E10 being used in winter (snowblowing, ploughing)?
If so, see to it that you can park your E10 in a location that is not
below freezing.
Or you can heat your batteries.
Charging your (Leaf) Lithium batteries when they are cold (below
freezing) will cause them to fail quickly from something
On 18 Mar 2024 at 12:21, William Swann via EV wrote:
> I am going to make a battery pack, with Leaf cells, for an E-10.
I take it you mean an Elec-Trak E10 electric garden tractor?
If so, you might be interested in this discussion list:
https://cosmos.phy.tufts.edu/mailman/listinfo/elec-trak
On 3/18/2024 10:21 AM, William Swann via EV wrote:
I am going to make a battery pack, with Leaf cells, for an E-10. Wish me
luck. Has anyone done so? I will test all Leaf cells from a wrecked Leaf
(for capacity) and make a pack with the best cells. Any suggestions on a
BMS to use? Or any
I am going to make a battery pack, with Leaf cells, for an E-10. Wish me
luck. Has anyone done so? I will test all Leaf cells from a wrecked Leaf
(for capacity) and make a pack with the best cells. Any suggestions on a
BMS to use? Or any other gotchas. It may be that I have to limit my