I did it almost exactly like Frank described and got a very good null.
My best settings were at zero too. Test receiver was a TS-870. W8XO
___
FlexRadio mailing list
FlexRadio@flex-radio.biz
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-rad
, 2007 4:12 PM
To: Philip Theis; [EMAIL PROTECTED]; flexradio@flex-radio.biz
Subject: Re: [Flexradio] Transmit image rejection
Just try putting the Flex on LSB with no mic connected. Put the test
receiver on the same freq but on USB. Key the Flex with the Transmit
Rejection "Enable TX Imag
dnesday, February 07, 2007 4:07 PM
Subject: [Flexradio] Transmit image rejection
I have also been unable to find a setting in either of the controls that
make a difference on the level of the transmit image. Using an HP
spectrum analyzer a
I have also been unable to find a setting in either of the controls that
make a difference on the level of the transmit image. Using an HP
spectrum analyzer as well.
Phil K3TUF
___
FlexRadio mailing list
FlexRadio@flex-radio.biz
http://mail.flex-radio
> Cc: FlexRadio@flex-radio.biz
> Subject: Re: [Flexradio] Transmit image rejection
>
> Ok, making progress, I found it in the manual. If in USB, which
> signal below the carrier? I have a bunch of them. No setting on the
> transmit rejection makes any difference that I can tel
Ok, making progress, I found it in the manual. If in USB, which
signal below the carrier? I have a bunch of them. No setting on the
transmit rejection makes any difference that I can tell. I do think
it works because I tried it using a spectrum analyzer earlier when my
spectrum analyzer wa
les Greene
Sent: Wednesday, February 07, 2007 9:50 AM
To: FlexRadio@flex-radio.biz
Subject: [Flexradio] Transmit image rejection
Hello,
I decided to use another receiver and perform the Transmit Image
Rejection. I can't find any thing on transmit image rejection (enter
that in the knowledge ba
ems
> -Original Message-
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
> radio.biz] On Behalf Of Charles Greene
> Sent: Wednesday, February 07, 2007 8:50 AM
> To: FlexRadio@flex-radio.biz
> Subject: [Flexradio] Transmit image rejection
>
> Hello,
>
> I decided to
Hello,
I decided to use another receiver and perform the Transmit Image
Rejection. I can't find any thing on transmit image rejection (enter
that in the knowledge base) or in the manual. I need to know which
frequency to tune my second receiver to, if I am using 7.1 MHz as the
frequency. Wh
receiver.
Eric Wachsmann
FlexRadio Systems
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Ken N9VV
Sent: Sunday, August 14, 2005 2:18 PM
To: FlexRadio Reflector
Subject: [Flexradio] Transmit Image Rejection settings?
Dear Flex persons,
With the Delta
Dear Flex persons,
With the Delta-44 my RX Rejection values are 3 and -14,
what are typical Transmit Rejection settings? are they
similar?
TU de Ken
--
Build: 8 succeeded, 0 failed, 0 skipped
11 matches
Mail list logo