Re: [Frameworks] Bolex EL Power question

2014-09-22 Thread Dominic Angerame
This is most helpful since I only shoot for a short period of time and spend most of the time editing and then shooting a bit more. This save me a lot of money because with an expensive battery I will run into the same issue and $15-$20 a pop seems more reasonable. Thanks Dominic On Fri, Sep

Re: [Frameworks] Bolex EL Power question

2014-09-19 Thread Scott Dorsey
The only kind of battery that comes as one big singular thing is Sealed Lead Aci d, essentially a miniu-version of a car battery. Yes. All of the Bescor belts I have seen were either AGM lead-acid batteries or gel-cell lead-acid batteries. They are heavy, but cheap and very difficult to

Re: [Frameworks] Bolex EL Power question

2014-09-19 Thread Dominic Angerame
Thanks all for your suggestions. I had the battery fully charged yesterday and tried to run the camera. The camera would not pull a 100 ft roll of film. I just heard a clicking sound sort of like a Rex5 doing single frames. However, the camera was on 18fps. This morning I plug in the battery once

Re: [Frameworks] Bolex EL Power question

2014-09-19 Thread Jean-Louis Seguin
If you're not using the camera often, you can power it from a 12V lantern battery available everywhere for around $15. They are not rechargeable but rated at 7Ah, so you have plenty of power for hours and hours of running. Jean-Louis On 2014-09-19, at 11:40 AM, Dominic Angerame wrote: Thanks

[Frameworks] Bolex EL Power question

2014-09-18 Thread Dominic Angerame
I own a Bolex EL and having battery problems. I have a bescor LCR portable rechargeable batter 12 volts 3.4. It charges up fine and the camera indicates that the battery is charged. However it will not advance nor can send power strong enough to transport the camera when loaded wiht a 100 ft

Re: [Frameworks] Bolex EL Power question

2014-09-18 Thread Scott Dorsey
What does the charge meter do when you turn the camera on? Don't worry about what it does when the camera isn't rolling, worry about what it does when the motor is on. If you have left that AGM battery on the shelf for a year or two without keeping it charged, it will be time to replace it.

Re: [Frameworks] Bolex EL Power question

2014-09-18 Thread Isaac Brooks
How old is the Bescor belt? It may need recelling. I know Bescor makes those belts that have a builtin output cable, which is usually kindof skimpy compared to a four pin xlr type cable, so it could be cable damage. NiCad batteries sometimes indicate a full charge and then suffer from lack of

Re: [Frameworks] Bolex EL Power question

2014-09-18 Thread Isaac Brooks
Ooof. Sorry, I was imagining a battery belt. Sorry, I think my info is bad. Isaac On Thursday, September 18, 2014, Isaac Brooks isaacbrook...@gmail.com wrote: How old is the Bescor belt? It may need recelling. I know Bescor makes those belts that have a builtin output cable, which is usually

Re: [Frameworks] Bolex EL Power question

2014-09-18 Thread Dave Tetzlaff
If it shows as charged, and then runs the camera at all just not well, does it still show as charged after that? A bad cable would likely produce intermittent power, not weak power. . The thing to do is isolate the source of the problem. Don't go out an get your battery recelled until you

Re: [Frameworks] Bolex EL Power question

2014-09-18 Thread Dave Tetzlaff
Ooof. Sorry, I was imagining a battery belt. Sorry, I think my info is bad. Any NiCAD/NiMH battery is made up of a number of individual cells, whether it be configured as belt or brick. !2V almost always = 10 cells at 1.2V ea. The only kind of battery that comes as one big singular thing is