Homer
Although I can't give you any difinitive answers, I may be able to point you
in the right direction.
You might want to read the section on Booting from an IDE device in the
bering users guide: http://leaf.sourceforge.net/doc/guide/bubooting.html as
you:
* may have copied ldlinux.sys to
Hi there,
Did you check the hosts.allow file in /etc ?
Jorn
Hello All,
After having little success in working out why i can not access weblet
from my internal network here are some of the outputs from the box. It is
a Bering version 1.2 running a dailup and one ethernet link.
I would like to use our Linux based MRTG system to monitor the network
traffic on a seperate LEAF Bering 1.2 system. I have looked at converting
it to Bering culibc and using the snmpd package. Unfortunatley I cannot
figure out how to configure the snmp daemons.
Does any one have either some
Either
1. recompile the kernel to include the ide drivers
OR
2. include the ide modules in the initrd.lrp package, and
have them loaded before you load the other packages.
Basically, the ide drivers need to be loaded BEFORE the package
list is loaded.
(I dont' have a CF Bering box handy, so
New to LEAF / Wisp using 2624
ok tried to install latest release of Wisp onto a 5BLMP motherboard with 8M
DoC. (Eon Anything box etc)
Able to get Doc setup, formated , syslinux etc all ok.
Kernel correctly located, and starts to run happily -
seems that it doesn't support the cs5530 chip which
Check your hosts.deny, and you should adjust your weblet config file to
reflect your internal network.
Default is for an internal network of 192.168.1.0/24 which you don't have
anymore.
Tony
-Original Message-
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] Behalf Of Robert
On Tue, 9 Sep 2003 15:12:13 +0530 S Mohan [EMAIL PROTECTED]
wrote
You say syslinux.cfg but bootup msg says LILO! Maybe that is the
problem.
Mohan
That was it... Found my old Dos boot disk, fdisk /mbr, then syslinux
again, and it works just fine... Thanks!!! I knew it was
On Mon, 8 Sep 2003, michel GONZALEZ wrote:
Hello,
Who cant tel me how can i boot bering with lodlin ?
Read the documentation for loadlin and Bering.
Example:
---config.sys---
[MENU]
MENUITEM=DOS,MSDOS... for NIC config
MENUITEM=Rtr,Bering Router Mode
MENUDEFAULT=Rtr,5
[common]
LASTDRIVE=Z
The Bering-uClibc team released today Bering-uClibc 2.0 beta4.
Most notable in this release are the upgrade of ppp/pppoe to ppp version
2.4.2b3 and the replacement of pump with dhcpcd.
Some changes in /etc and weblet, and the usual dropbear upgrade.
For a complete Changelog please read:
Hi all
I have 2 Adsl Router with both 128K .. I would like to set load balancing on my
bering box but I have no idea about that.. I try to search information on internet..
Anyone know please tell me..
thanx.
---
This sf.net email is
10 matches
Mail list logo