I've only made one hollow spiral before, not on the legacy. I wrapped long
1 wide strips of sandpaper around each spiral segment and just pulled the
sandpaper back and forth until the inside of the spiral got smooth. I
should note that I used a drill press to make the hollow spiral, so the
something i was always going to try but didn't was to mount a dermal with a
little flap sander in it on the mill at the right angle and follow it using the
correct pitch to remove that sharp edge on the inside you get when doing
hollow spirals on the mill, but i never got around to it. if you
Bill,
I checked eBay and Google here in the USA - no hits for this Bosch
sander. It is my guess that this sander was made for certain markets
(your country being one?) - with the United States not being one.
I have never seen the tool here. And based on a few comments I read
about it, my guess
