I'm getting back into Machinekit and am looking for recommendations for a
configuration for use with the 3 axis MPCNC router. Most MPCNC builders use
a RAMPS board and run either Marlin or GRBL. I have been using LinuxCNC but
want to try something closer to the RAMPS configuration for another
I'm using the standard T8 leadscrew, works fine on my first machine.
Are you using Jessie? Do you use an HTML monitor or do you have a remote
setup?
On Wednesday, 7 March 2018 16:51:47 UTC-8, Tom M wrote:
>
> Hi I have my MPCNC running very nicely using a cramps board.
> Here is link to my
Thanks for the advice, I have settled on Beaglebone Black rev C, CRAMPS 2.2
and Debian Jessie. I have loaded Stretch and it works though I have found
no substantial benefit and think it might be more bloated and slower than
Jessie, though I have not done any extensive testing to prove this.
