Leaking lift pump.
Peter
-Original Message-
From: Harry Watkins [EMAIL PROTECTED]
Sent: Jul 22, 2008 12:58 PM
To: Mercedes Discussion List mercedes@okiebenz.com
Subject: [MBZ] OT Small diesel engine fuel problem
I keep getting air at the middle injector nut during bleeding. The two
Peter wrote Leaking lift pump.
Peter, would that be an individual pump for that middle delivery valve? In
other words are there three lift pumps?
Thanks
Harry
On Tue, Jul 22, 2008 at 12:34 PM, Peter Frederick [EMAIL PROTECTED]
wrote:
Leaking lift pump.
Peter
-Original Message-
Peter Frederick wrote:
Leaking lift pump.
And that would show up on only one cylinder?
I was thinking delivery valve or injector.
One could swap them around, see if the problem moves.
Mitch.
___
http://www.okiebenz.com
For new parts see official list sponsor:
On Tue, Jul 22, 2008 at 12:43 PM, Mitch Haley [EMAIL PROTECTED] wrote:
Peter Frederick wrote:
Leaking lift pump.
And that would show up on only one cylinder?
I was thinking delivery valve or injector.
One could swap them around, see if the problem moves.
**I'll give the swapping out a
Harry Watkins wrote:
**I'll give the swapping out a try if the new springs and seals fail to fix
it. I know I can remove the spring, seal and valve but I'll have to see
about the valve seat, I don't want to mix those.**
If you have a couple of spare injector tip seals, it shouldn't take long
On Tue, Jul 22, 2008 at 3:22 PM, Mitch Haley [EMAIL PROTECTED] wrote:
If you have a couple of spare injector tip seals, it shouldn't take long to
swap
injectors, then you'll know if you need to keep messing with the pump.
** Good point Mitch, you're right. I have the IP off now, so one at
I think that the injector might need rebuilding. Compression from the
cylinder coming back into the injector because of a problem with the
nozzle not shutting or spring pressure too low. Try taking one from one
of the other engines you have and use it. Shouldn't take very long to do
that.
On Tue, Jul 22, 2008 at 6:32 PM, MG [EMAIL PROTECTED] wrote:
I think that the injector might need rebuilding. Compression from the
cylinder coming back into the injector because of a problem with the
nozzle not shutting or spring pressure too low. Try taking one from one
of the other engines