Hi Michelle,
I'd take a close look at:
1. SATA cable, try replacing it. Check that connectors are ok on the
mainboard(firmly seated, no obvious soldering issues). Check that the
cable does not have any kinks or sharp bends(a bend radius smaller that
a golfball might give you issues -especially
AHCI was already enabled. The IDE mode was legacy, so I've turned that
off and a few other settings, but there's only so far I can go.
So far, the OS is booting without the need for re-installation as it
was already AHCI... but... well
Michelle.
On Sun, 2021-08-29 at 14:56 +0300, Toomas Soo
I've done workaround number 5 in that document.
The system has been working for years, and I'm not sure about the
AHCI... will have to look at that as that will require an OS rebuild, I
believe.
The only thing that's changed before this started happening, was the OS
upgrade. But obviously there's
root@jaguar:/var# iostat -En
c6d1 Soft Errors: 0 Hard Errors: 0 Transport Errors: 0
Model: KINGSTON SA400S Revision: Serial No: 50026B73801BCEA
Size: 120.03GB <120033607680 bytes>
Media Error: 0 Device Not Ready: 0 No Device: 0 Recoverable: 0
Illegal Request: 0
c4t0d0 Sof
> On 29. Aug 2021, at 14:31, Michelle wrote:
>
> I'm sat here, not knowing quite what I'm dealing with.
>
> OI recent build on HP N54L, as you may remember I hit a problem on the
> 8th August with rpool encountering an error on the SSD with the OS.
>
> I replaced the drive and had the same th
I have the machine up and running and issued a zpool clear against
rpool. At least as long as it lasts.
Reading things from ten years ago, I've disabled the microcode... it
seems to be all I can do. I'm not expecting that to be the issue but...
hey.
Nothing in /var/log/syslog which gives any clue
I'm sat here, not knowing quite what I'm dealing with.
OI recent build on HP N54L, as you may remember I hit a problem on the
8th August with rpool encountering an error on the SSD with the OS.
I replaced the drive and had the same thing straight away. Replaced
with another drive and took the uni
