it be better to set the pad to the GND
net?
Regards, Peter
-Original Message-
From: Alfonso Baz [mailto:[EMAIL PROTECTED]
Sent: 08 March 2003 20:22
To: Protel EDA Forum
Subject: Re: [PEDA] How to make PCB mounting holes?
Peter,
Have you assigned a net to the pad
Alfonso,
No, I set it to 'no net'. Would it be better to set the pad to the GND
net?
Regards, Peter
-Original Message-
From: Alfonso Baz [mailto:[EMAIL PROTECTED]
Sent: 08 March 2003 20:22
To: Protel EDA Forum
Subject: Re: [PEDA] How to make PCB mounting holes?
Peter,
Have
On 08:08 PM 8/03/2003, Peter Moreton said:
Hi,
I'm using 99SE, and trying to make a set of M2 mounting holes on a small
pcb. I created 2.5mm pads with 2.0mm holes, and placed these on the
board using the PCB editor, between my components. However, when I
autoroute the board, some of the holes
I tend to have the mounting holes as schematic components, there
they're called M3. There they can be assigned a net, eg GND, EARTH,
or nothing. Then they have an M3 footprint, too.
When you have placed these footprints, lock them.
Rene
Peter Moreton wrote:
Hi,
I'm using 99SE, and trying
Peter,
Have you assigned a net to the pad?
From: Peter Moreton
Hi,
I'm using 99SE, and trying to make a set of M2 mounting holes on a small
pcb. I created 2.5mm pads with 2.0mm holes, and placed these on the
board using the PCB editor, between my components. However, when I
autoroute the
