I soldered a jumper between the collector of Q6 (PL INDICATOR output switch)
and PIN 14 (XMIT PL INHIBIT). I also removed R35 (which was a pull-up resistor)
Now the PL is ON during COR only
Eric VE2TSO
--- In Repeater-Builder@yahoogroups.com, ve3...@... wrote:
so Eric- to clarify your
Eric tnx for the info, will try here on two repeaters
Jerry VE3 EXT
so Eric- to clarify your mod---what exactly did you do ?
Tnx
Jerry VE3 EXT
I found the schematic yesterday and found that PIN 14 is XMIT PL INHIBIT and
PIN 5 is PL INDICATOR. Now the TX PL is active only on valid PL on the receive
side !!
Thank's to all who helped me. I appreciated.
Eric VE2TSO
--- In Repeater-Builder@yahoogroups.com, kk2ed kk...@... wrote:
I
I believe Pin 14 on the PL board is the encode disable pin. Simply grounding
this pin disables the encoder. You can also find a COS signal at pin 5 of the
squelch gate slot. It is active high.
Using two NPN transistors, and a few 10k resistors, you can have the COS drive
the first
Eric ve2...@... wrote:
Hello,
Is there a way to configure the TRN5073A PL board to TX PL
only during COR ? Actually, PL is always ON, even during the
dropout delay.
Probably, but it would be an involved mod with some serious
thinking required to get it done. I did it once using an
6 matches
Mail list logo
