Are sure it has been certificated for the current narrowband emission mask?
Ham, fine if it isn't.
Part 90, it ain't legal if it hasn't.
Take the FCC ID to:
https://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
and see if it's approved for 11K0F3E, Mask D.
WalterH
--- In
Re: Need MSR2000 PL Reeds or alternate suggestions
Thanks everyone for their feedback. I have two reeds on order from
MDM and will just go with that.
Yes, I've told the customer that by 1/1/2013 we'll have to be
narrowband, but this is a short-term backup solution so by
then we'll
kt...@ameritech.net wrote:
Thanks everyone for their feedback. I have two reeds on order from
MDM and will just go with that.
Yes, I've told the customer that by 1/1/2013 we'll have to be
narrowband, but this is a short-term backup solution so by then we'll
figure out something.
Thanks everyone for their feedback. I have two reeds on order from MDM and will
just go with that.
Yes, I've told the customer that by 1/1/2013 we'll have to be narrowband, but
this is a short-term backup solution so by then we'll figure out something.
--- In Repeater-Builder@yahoogroups.com,
Hi Tony,
I have seen a situation where a section of thin aluminum plate
was cut to fit on/over the original PL module. A Comm Spec
TS-32 was placed on the Aluminum mount/plate with double sided
tape and parallel interfaced with the original MSR-2000 PL
module. The plate stood off from the
From: skipp025 skipp...@yahoo.com
To: Repeater-Builder@yahoogroups.com
Sent: Tuesday, May 12, 2009 10:09:04 AM
Subject: [Repeater-Builder] Re: Need MSR2000 PL Reeds or alternate suggestions
Hi Tony,
I have seen a situation where a section of thin aluminum plate
was cut
6 matches
Mail list logo
