on the high side would improve reliability of HI logic state.
If you want to contact me off-line: buehl at superlink.net
Tom Buehl
At 06:58 PM 9/24/2008 +1000, you wrote:
Hi,
I have just spent a week or two trying to talk to a Trimble Thunderbolt.
I have a laptop running VISTA, about
Emmanouil
Sorry for delay, but took me a while to find where it was stored.
I have a .pdf copy of the manual.
Cna email if your server will accept 7 MB attachment.
contact me off-line.
buehl -at- superlink.net
Tom Buehl
At 09:21 PM 9/1/2008 +0300, you wrote:
Hi
I am searching
It looks like APC will provide software download for free from their website..
http://www.apcc.com/tools/download/index.cfmAt
Tom Buehl
12:07 PM 4/18/2008 +1000, you wrote:
Dennis,
Ah-ha. Now here's the rub!
I've got 2 such APC Smart UPS - but I cannot find, beg, borrow or steal
a copy
OOPS !
Cannot go directly to download page at APC.
But from the 'failure' page which comes up, click SUPPORT at top;
This gets you to
http://www.apcc.com/support/index.cfm
Then click SOFTWARE FIRMWARE in the SELF HELP column at left side.
(in windows)
Tom Buehl
At 12:07 PM 4/18/2008 +1000
looking until decoded (language package installed).
Tom Buehl
At 04:39 PM 8/21/2007 +0200, you wrote:
); SAEximRunCond expanded to false
Errors-To: [EMAIL PROTECTED] RETRY
Friends,
because I received the first of my messages completely garbled as Rob
díd, I send it a second time and received
of mass and the face of the club, along a
line normal to the surface. This potential energy is then converted back
into motion (kenetic energy) and the direction of this motion is normal to
the club surface.
Very different than a light beam or wavefront reflecting off of a surface.
Tom Buehl
was less, then he would have needed to bid again; which
eBay says would result in the new bid submission being displayed.
Tom Buehl
At 03:17 PM 4/26/2007, you wrote:
In a message dated 4/26/2007 05:23:48 Pacific Daylight Time, [EMAIL PROTECTED]
writes:
Can anyone propose a sequence of bids on dates
Rasputin:
As a lover of fine kitchen knives, I can appreciate your decision.
And of course there is the 'time nut' measurable advantage of time per
slice, for a ripe cucumber, being only 42.467 mS instead of the typical
43.125 mS.
Tom
At 08:18 AM 4/20/2007, you wrote:
Well, stupid may not
is lower than the level in the oven pot. Flow rate is dependent on
the difference in the fluid levels, with the oven loosing less heat when
the 'outside' pot is at a higher level. (higher temperature)
Tom Buehl
___
time-nuts mailing list
time-nuts
such a device.
Tom Buehl
EFFECTIVE SOLUTIONS
At 03:27 AM 9/29/2006, you wrote:
How about pinching an idea from the early radar and missile technologies
- Conical Scanning. Basically you offset the detector of feed antenna
from the point of focus and then rotate it. If the signal is off centre
you
; Contact me off lis.
Tom Buehl
[EMAIL PROTECTED]
At 11:13 PM 7/17/2006, you wrote:
Folks,
Heads up on this eBay seller: Test Equipment Surplus, eBay id
http://pics.ebaystatic.com/aw/pics/s.gif
http://feedback.ebay.com/ws/eBayISAPI.dll?ViewFeedbackuserid=jtseleii
d=7614062550frm=284ssPageName
of the rise, which is important for a
clocking application.
I put a nominal R in each output path, 22 Ohms in my case, to limit current
from section to section. Then at the junction of all these output
resistors, I put a single R to the output connector to set the desired
output Z.
Tom Buehl
allows
electrolytic barrier to re-form. Repeat this a dozen times over the
course of a day.
Tom Buehl
At 03:23 AM 4/4/2006, Robert Atkinson wrote:
Hi all,
Using a Variac over a long period of time is great with conventional
(Transformer-rectifier-capacitor) linear PSU's, but be careful
Can anyone provide info on a source for manuals for Tektronix 1240 logic
analyzer and HP 8565A spectrum analyzer?
Also information on probes and output connections for the Tek 1240 would be
appreciated.
Thanks,
Tom Buehl
___
time-nuts mailing list
cartridges.
-Chuck Harris
buehl wrote:
Can anyone provide info on a source for manuals for Tektronix 1240 logic
analyzer and HP 8565A spectrum analyzer?
Also information on probes and output connections for the Tek 1240
would be
appreciated.
Thanks,
Tom Buehl
Chuck:
User data noted; So power off while changing is OK.
Thanks,
Tom
At 03:30 PM 3/10/2006, you wrote:
buehl wrote:
Chuck:
Thanks for warning.
Do I have to have unit powered up when changing battery?
Oops! I read changing to be charging.
The only data the cells protect is user
project. Unfortunately I do understand
nothing of these new devices.
I would like to keep in touch with you, thank you.
ON 16 OCT TOM BUEHL WROTE:
Arnold:
Some more info regarding use of Xilinx FPGA for counting.
I recently completed a design using Xilinx Spartan II FPGA. This FPGA is
only
pulse
(limited by the rise/ fall time of the logic).
Regards, Tom Buehl
However, even
with a arrangement like that, i would expect the device to have a
minimal delay of say the propagation delay of the comparator plus one or
two gates in a current semiconductor technology, so '0' to x.xxx ns
18 matches
Mail list logo