On 03/15/2018 12:27 AM, Zhongyuan Zhao wrote:
Hi Marcus and Derek,
Thank you for the reply. The RFNoC and synchronization are very
helpful. I have an additional question regarding to the timestaming in
GNURadio.
In the VITA and CHDR format of RFNoC, there are timestamp and stream
ID, what
Hi Marcus and Derek,
Thank you for the reply. The RFNoC and synchronization are very helpful. I
have an additional question regarding to the timestaming in GNURadio.
In the VITA and CHDR format of RFNoC, there are timestamp and stream ID,
what could I do to keep the timestamp and stream ID via a
I found that UBX has a bit less of spurs. I assume it is because the whole
daughterboard is covered by heatsink panel that plays a role of EMI shield
while SBX is open.
thanks,
Dmitry
From: Hojoon Yang via USRP-users
Sent: 14 марта 2018 г. 9:23
To: usrp-users@lists.ettus.com
Subject:
On 03/14/2018 05:36 AM, Lucas Val Terrón via USRP-users wrote:
Hi all,
Working with the example "tx_waveforms.cpp" provided in the uhd, i
found myself with two problems trying to set the sample rate and the
tx bandwith of the USRP B210 (UHD_3.11.0).
./tx_waveforms --rate 6144 --freq
On 03/14/2018 02:45 AM, Brandon Piner via USRP-users wrote:
I have found that it starts happening with low sample rates around 2
Msps and then stops overflowing. It happens all the time with higher
sample rates.
I tried to rule out my code from this by having it run in a thread
that just
Hi all,
Working with the example "tx_waveforms.cpp" provided in the uhd, i found
myself with two problems trying to set the sample rate and the tx bandwith
of the USRP B210 (UHD_3.11.0).
./tx_waveforms --rate 6144 --freq 235000 --wave-type SINE
--wave-freq 100 --gain 40 --bw 5000
Hello Hojoon Yang,
Both SBX and UBX will work fine (*Assuming X3x0 series only, no N2x0 or older
boards).
You can align the phase of the UBX and SBX boards by using the timed commands (
https://kb.ettus.com/Synchronization_and_MIMO_Capability_with_USRP_Devices ) ,
but you will have to
==
* Reminder *
(there is still space available)
==
Ettus Research will be running a series of free, hands-on,
I have found that it starts happening with low sample rates around 2
Msps and then stops overflowing. It happens all the time with higher
sample rates.
I tried to rule out my code from this by having it run in a thread that
just reads from the device and then discards the data afterwards.
Hi.I have two USRP X310s and wonder which board between SBX and UBX would be
the suitable for me.I'm gonna buy four daughterboards to use it as 2x2 MIMO.
One USRP X310 for Tx, the other USRP for Rx.My target frequency is from 1.8GHz
to 2.8GHz. According to datasheet, Both UBX and SBX work on
10 matches
Mail list logo
