On Tuesday 07 August 2001 22:53, Trevor Antczak wrote:
> Hello,
> SuperMicro S2QR6 Motherboard
> 4 Pentium III Xeon 700 Mhz CPUs
> 8 GB of RAM (16 512 MB registered ECC PC 100 DIMMs by Viking)
> ATI Xpert 128 Video card ( 16 MB of RAM, PCI)
> 2 Ultra 160 SCSI Seagate Drives (36 GB a piece, 80 pin SCA interface.
> They plug into the built in Adaptec 7899 controller on the motherboard)
> Various other components (Asus CD ROM, Yamaha Burner, floppy, etc.)
>
> Now the problems:
>
> 1) X refuses to work. The X based graphical installer works fine, other
> than the fact that is cannot test the X configuration you setup for
> after the install. Attempts to use Xconfigurator result in it
> generating a complete XF86Config file, but upon trying to test it
> bringing up a message that "There is an Error in you XF86Config file"
> and offering you a choice to go back and try again (never works) or
> exit. startx looks like it working but fails after a few seconds. I
> have attached my log file from a "startx", but I think the critical
> lines are:
>
> (II) Primary Device is: PCI 01:04:0
> (--) Assigning Device section with no busID to primary device
> (EE) No devices detected
Hi
i am not sure but i recall that there been some problems
with some ATI board but i dont use them so i havent save those mails
check the archives and verify with www.xfree.org and hardware.redhat.com
sorry that i cant be more helpful
but this should get you going
regards Jörgen
_______________________________________________
Seawolf-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/seawolf-list
