Hi Jonathan,
It looks like you are all set, both enable commands worked fine.
It is normal that a backend shows an <unknown> checkpoint once it has
been enabled. As soon as a backend is enabled, it does not correspond
anymore to the checkpoint it was enabled from since potentially writes
are currently being executed on it.
Actually, if you did a 'show backend' between the restore and enable
operation, you would have seen the checkpoint.
Looks like you are good to go now,
Emmanuel
--
Emmanuel Cecchet - Research scientist
EPFL - LABOS/DSLAB - IN.N 317
Phone: +41-21-693-7558
_______________________________________________
Sequoia mailing list
[email protected]
https://forge.continuent.org/mailman/listinfo/sequoia
