10 hours after the last post I start my PC and login then start Plone Controller it says Plone is running (just as it did last night) and click View and up comes the site.
Last night after three reboots and hitting refresh etc. Plone was a blank page. This morning with nothing other than being shut down for 10 hours its' working again. There must be something holding onto the port for a period then timing out. I think that the previous execution of Plone holds the port even after it has been stopped and then it stops Plone running again. After a set period of time it is removed. Can this be something about the 32 bit and 64 bit stuff on Winx64. Even with other apps registered as default (Firefox, Mozilla etc.) MS apps get fired up every now and then its far from working correctly. It must be such a quirk happening here on the ZopeDB port. How can I stop Plone and ZODB from the command line? Chris Chambers -- View this message in context: http://www.nabble.com/Documentation-of-ZOPE_MANAGEZODB_PORT-Access-and-Winx64-tf3380067.html#a9440426 Sent from the Plone Setup mailing list archive at Nabble.com. _______________________________________________ Setup mailing list [email protected] http://lists.plone.org/mailman/listinfo/setup
