Hi Curt,
As the machine is booting, you should have some lines that look similar to
the following:
ne.c:v1.10 9/23/94 Donald Becker ([EMAIL PROTECTED])
NE*000 ethercard probe at 0x340: 00 40 05 19 27 84
eth0: NE2000 found at 0x340, using IRQ 10.
NE*000 ethercard probe at 0x300: 00 40 33 d0 f7 da
eth1: NE2000 found at 0x300, using IRQ 11.
If both sets don't show up, then one of your NICs is not being properly
initialized. If they do both show up, then it's probably a
mis-configuration of your external ethernet. Perhaps the IP address or
network mask is incorrect.
Regards,
John Lombardo
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Curt Pederson
> Sent: Thursday, November 18, 1999 9:12 AM
> To: [EMAIL PROTECTED]
> Subject: [ShareTheNet] Configuration Problems
>
>
> Hello,
>
> I am trying to get STN 2.1.3 working with DSL. I have an old 386dx40 w/
> 2 NE2000 nic's in it. I have the nic's configured properly and all of
> my settings seem to be correct. When I boot STN, it loads all of the
> settings fine and I get the 'ShareTheNet VERSION=2.1.3' as the last
> line. When I run an ifconfig on the box, it shows lo and eth0 but not
> eth1. eth1 is my nic that hooks into my modem. I switched the
> configuration to switch the cards to make sure one of the cards is not
> bad. Both cards work when they
> are on my internal network.
>
> Everything I try doesn't get my STN box to get an IP from the DSL
> provider. I know my modem works because I hooked it up to my NT box and
> was able to get on the net. I am even trying a config file from a
> friend who is using the same DSL provider as I am. Still no luck.
>
> Any ideas?
>
> Thanks
>
>
> _______________________________________________
> ShareTheNet maillist - [EMAIL PROTECTED]
> http://www.webserv.com/mailman/listinfo/sharethenet
>
_______________________________________________
ShareTheNet maillist - [EMAIL PROTECTED]
http://www.webserv.com/mailman/listinfo/sharethenet
