|
Hi;
Back to golf. I didn't mean to start a passionate
discussion over ZA. Sorry 'bout that.
I played a round with a guy who was using a
10.5� Cobra 427 cc driver with a Grafalloy "R" flex shaft. I assume it was
a 3.5. I couldn't tell because it was an OEM special. Markings on the club sole
indicated the volume and the COR - .828 I think. The guy was a high handicapper
but with the driver he was a single digit. He absolutely killed it. So, I
grabbed a demo from the proshop and hit a few shots with it. The shaft
seemed to be pretty stiff and "boardy." But then, I had had a couple of
libations prior to the test so I quit. I went back the next day and borrowed the
demo again. I hit about 30 balls with it. I'll swear that shaft is considerably
stiffer than the "S" flex shafts I have installed in my GBB, 975J, Ping TiSi,
Aermet, LSC, and a few others. Later, I borrowed another club from one of the
guys at the course and hit several more balls with the same result. That "R"
flex Grafalloy is as stiff as a board.I didn't have the opportunity to check out
the frequency on my ClubScout. So, I'm curious -
have any of you guys hit this club/shaft combo? I've installed a lot of
Grafalloy 3.5 "R"s and have played them as well. I've never come across one as
stiff as the 3 I recently tried.
TFlan
|
