Re: ShopTalk: SA 2000 contact info

[Don Flatgard]

I've used brushes to but didn't think they did a very good job and they wear out to fast. Thought about a stone but I am afraid a grinding stone would make the hosel to big and uneven. It don't take long with sandpaper, I cut a bunch all at the same time and it's cheap. (I am a cheap ass)  df ----- Original Message ----- From: [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Friday, August 29, 2003 2:17 PM Subject: Re: ShopTalk: SA 2000 contact info In a message dated 8/29/03 2:53:16 PM Eastern Daylight Time, [EMAIL PROTECTED] writes: I cut sandpaper into about 1 1/2" by 4" strips that I roll and fit around a  drill bit to use in the drill press to clean the inside of the hosel. Too much work! Buy a 3/8" power tube brush, chuck it in electric hand drill and run it in the hosel! Really tough job (like cleaning epoxy gunked hosel) use a round grind stone! These are for die grinders and  will fit electric drill or Dremel tool. I love work but hate making it hard! Arnie