Re: ShopTalk: reaming bc wedges

[Fjbold1]

In a message dated 10/27/2003 11:52:15 PM Eastern Standard Time, [EMAIL PROTECTED] writes: Hi, Thanks for your prompt response. Im not a rocket scientist or a machinist but what I gather from looking at this site is that I would do better to use a slower feed and lower rpm. Is this right? Thanks, David Hi David, That is right. Also the type of cutting fluid you use will make a difference. The one that I remember using was called Winbro Tap Free, another was called Cool Tool, they were a thin solution, not a heavy oil. You could have a stuck tap and put a little Tap free on it and as the name implies, it would free it immediately.                                                                             Frank