Credit card or a check. A check is preferred. BTW there is a picture of the laser/holder on the accessories page on my web site. www.csfa.com
Cheers, John K ----- Original Message ----- From: comgolf <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, June 04, 2004 10:36 PM Subject: Re: ShopTalk: Miscellaneous thoughts > How do i pay you to get one?? > > PayPal..?? > > Thanks > John > > ----- Original Message ----- > From: "John Kaufman" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Friday, June 04, 2004 9:26 PM > Subject: Re: ShopTalk: Miscellaneous thoughts > > > > Hi Jen, > > > > I offer a laser and a holder that attaches to a shaft. It can be used with > > raw shafts or finished clubs. The laser/holder combination is $15. They > were > > a hot item at the PCS show. I had about 40 with me at my booth and sold > out. > > > > Cheers, > > > > John kaufman > > > > ----- Original Message ----- > > From: Jen Kuntz <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Friday, June 04, 2004 11:57 AM > > Subject: Re: ShopTalk: Miscellaneous thoughts > > > > > > > No problem. > > > > > > What I recall of it was he had a laser pen (?) that he attached on the > > > end of the shaft (can't remember how) and he clamped the shaft in what I > > > think was the clamping device he used for the frequency meter (he has > > > one of John Kaufman's machines). He would put the shaft in parallel to > > > the workbench (if that isn't obvious!) and twang it parallel with the > > > workbench as well with the laser pointing at the wall so you would see > > > the visual pattern quite easily. Some oscillated a fair bit and the > > > "good" ones eventually oscillated at a relatively flat line. He would > > > rotate the shaft until he found the "best" FLO pattern. (I may not be > > > using the best terminology here). > > > > > > It was quite simple looking. What I am hoping to get more information > > > on is how he attached the laser pointer and where he got it etc. The > > > clamping would also be a question as I do not have a freq. meter and I > > > think I would be "stuck" clamping in a vice. > > > > > > If I get more info, I will pass it on. > > > > > > Jen > > > > > > BTW - this is Patrick Inglis that I am speaking of... used to be on > > > ShopTalk but I don't think he is anymore. > > > > > > > > > comgolf wrote: > > > > Hi Jen: > > > > I'd like for you to explain that laser device after you see it if you > > don't > > > > mind. > > > > > > > > Thanks > > > > John > > > > >
