They can be bent with no problems, I have a Mitchell........... IMO, I stripped a ping JZ stiff and found that the tx-90 reg was almost dead on.
jay ----- Original Message ----- From: "Steve Prescott" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Saturday, May 21, 2005 6:28 PM Subject: ShopTalk: Ping ISI > I recently picked up a set of Ping ISI-K irons that were built in 1996. > Ping's web site says the ISI > can be bent 4* but add this note: > Notes: As indicated in the chart above, the amount of adjustability for any > iron is primarily determined by > the metal and its age. Another important factor is the number of adjustments > that have been made to the set in the past. > > I am sure these have not been adjusted in the past so I'm not too concerned > about that aspect but the age > has me wondering. The set was built as a red dot (1* flat) but over the > years they have flattened > between .2 and 1* (assuming they were at target * at some point) The lofts > are anywhere from > OK to 1.2* strong as well. > > Any precautions or tips on bending this 9 year old steel ? > > I hit the 7 iron today which was my first experience with the JZ shaft. > Kinda like it. I was afraid the stiff > (I play DGSLR's @ D4) was going to feel boardy and heavy. Not the case. I > really didn't notice the C-7 > swing weight either. So much for my feel- but they sure are easy to hit. > Ugly But........ or is that ...Butt Ugly > Does T. Temper make this shaft for Ping ? > > Regards > Steve > > >
