If you want a wrap on you take a Winn grip warm it a little, lift the collar and unwrap the grip. Now cut off the underlisting about 1" from the butt cap , this becomes the grip cap which is better than those made for the Goldwin shafts!
Cut a small slot in the edge of the shaft butt. Place the start of the Winn wrap in the slot, push into the butt the butt cap you made, wrap the grip and finish with a strip of good quality vinyl electrical tape. Tip: Do not stretch the electrical tape and it won't unpeel.
-----Original Message-----
From: Jeff Stephens <[EMAIL PROTECTED]>
To: [email protected]
Sent: Thu, 18 Aug 2005 05:09:59 -0400
Subject: RE: ShopTalk: Goldwin Grip?
John,
If you have any of the wrap on grips that might do the trick. Let me know. Thanks in advance.
Jeff
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of John Payne
Sent: Wednesday, August 17, 2005 6:34 PM
To:[email protected]
Subject: RE: ShopTalk: Goldwin Grip?
Sent: Wednesday, August 17, 2005 6:34 PM
To:
Subject: RE: ShopTalk: Goldwin Grip?
Jeff
I may have a Tour Velvet grip for "big butts" that would work. I used them on some of the big butt shafts that used to be sold but not on a Goldwin shaft. I may have some of the wrap-on types that were used on them too, will have to check the basement. Let me know if you're interested.
John
