Agree. I use a dremel to cut that slot most of the time. Sent from my iPhone
> On Mar 27, 2015, at 7:11 AM, André Cantin <[email protected]> wrote: > > GW has them at .363 with the following mention: > > .363" t > > ** These Callaway Iron must have slot cut lengthwise in the tip of the shaft > when reshafting as is done from the factory > > Good luck > > > From: Ron Blanchard > Sent: Thursday, March 26, 2015 8:40 PM > To: [email protected] > Subject: ShopTalk: Callaway X-Tour iron shaft question > > Hey gang, > > Are these shafts just standard .355 tapers that are blind-bore? > > Thanks! > > > -- > Ron Blanchard > > > No virus found in this message. > Checked by AVG - www.avg.com > Version: 2015.0.5751 / Virus Database: 4315/9388 - Release Date: 03/26/15
