its on. the problem only exists when I try to install lilo from 2.4.x. I don't change any configs, and use the same map, kernel, config, and lilo executable as when I'm in 2.4.x, but it installs properly when running on 2.2.x
On Monday 01 October 2001 09:30 am, you wrote: > Are you sure you turned LBA on? I don't know if it's default on debian > unstable, but the error sounds consistant with an LBA error (though > admittedly, a lot of errors.) Just add lba32 on its own line to the top > of your /etc/lilo.conf file to activate it. Best of luck. > > -Ryan > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]] On Behalf Of Patrick Lang > Sent: Monday, October 01, 2001 7:14 PM > To: [EMAIL PROTECTED] > Subject: debian kpkg > > > I am having some strange problems with make-kpkg. > > Here's my procedure: > make menuconfig > make-kpkg clean > make-kpkg --revision=hostname.x kernel_image > dpkg -i ../kernel-image-2.4.10_tarvalon.x_i386.deb > > dpkg claims it installed lilo, but when I reboot, I get either LI, LI- > or it > says loading linux ............. and never reaches uncompressing > > I've tried dpkg -i , sync, then lilo AGAIN, and AGAIN before rebooting > and it > does the same thing. The only time LILO works is if I boot off the > debian > stable floppy boot disk with root=, run lilo, then reboot. that works > every > time. > > Any ideas? > > here's my layout: > /dev/hde1 fat32 win2k partition > /dev/hde2 ext2 > /dev/hde3 ext2 (boot/root, active) > /dev/hde4 swap > /dev/hdg1 fat32 > /dev/hdg2 extended > /dev/hdg3 ext2 > /dev/hdg5 swap > > I'm running debian unstable, lilo, and debian's mbr on hde. > ------------------------------------------------------------------------ > --- > Send administrative requests to > [EMAIL PROTECTED] --------------------------------------------------------------------------- Send administrative requests to [EMAIL PROTECTED]
