Hello, I'm a newbie when it comes to Linux. I started out with Redhat cuz of
its popularity, but after some comparison to Caldera, I switched over. Caldera
is much easier to use w/ KDE and all. Anyhow, I had set up my PCI AWE64 doing
the following under Redhat:
insmod sound
insmod uart401
insmod sb io=0x220 irq=5 dma=1,5 mpu_io=0x330
insmod opl3 io=0x388
depmod -a
This seemed to work fine for Redhat. However, I tried this under Caldera and
it doesn't work. After rebooting, the modules did not load. So, I resorted to
using lisa. I found the sound module under lisa's list and tried to add it but
lisa gave me an error message saying it couldn't find the sound module. I
tried the insmod method again and it seemed to work fine. I used Lisa to get a
listing of the loaded kernel modules and all of the ones I added were there. I
rebooted and, again, no sound module were loaded. I checked the lisa listing
of loaded modules and my sound modules had mysteriously disappeared. What
should I do? Its not the sound that is so importatnt, its the fact that I
don't even know how to load a module anymore. Any help would be appreciated.
--
(Signature Best viewed with Courier 10)
__________________________________________________________________<>______
| __ "Seek the truth and it shall set you free." || |\
| //\\ -== David Hudgens ==- || | |
| || || [EMAIL PROTECTED] .____||____. | |
|<\___\\//___/> -== Asebun Wunowh ==- </~~~\()/~~~\>| |
|</~~~~||~~~~\> [EMAIL PROTECTED] ` |``| `| |
| ` || ` http://ccwf.cc.utexas.edu/~asebun/ | | | |
| || /|\ | /|\ |\ | |\/ |_// `|\/| /|\ |\ |\/| |\ | | | |
| || | |/ | |\ `|\ |\/ |-~ |_ | |- |/` |_ | |/` | | | |
| /__\ ~| | | | | | | | \| | | | \| |\ | | | |
|________________________________________________________________ | | ____| |
\________________________________________________________________`\/`______\|
---------------------------------------------------------------------------
Send administrative requests to [EMAIL PROTECTED]
