First - rh has updated pump that works with roadrunner - look in rh6 updates
or use rpmfind.
Second - if you got ip masqing going on - you may have some routing issues.
I use routed and things run good for me.
Third - try out the initscripts from rawhide - I'm using that and I although
it may be my imagination, things worked better afterwards. I can verify that
pump renews its lease about every two hours.
Fourth - cable modem should go directly into one ethernet of your linux box.
Dont hook cable modem directly to hub.
Fifth - second ethernet comes out of box into hub.
Sixth - for ftp'ing make sure you got the ip_masq_ftp module loaded.
Cheng Zhou wrote:
> I've managed to successfully install Roadrunner on my rh 6.0 box
> along with ip masq and co. Unfortunately, it seems like I'll only
> enjoy nice bandwidth for a pretty short amount of time (typically about
> an hour or so, sometime more, sometimes less). After that, everything
> starts bogging down. The real surprise is that if I kill the dhcpcd
> and start a new one, performance goes back to "good" for a while
> and then drops again. Anyway, although rh 6.0 ships pump, it doesn't
> seem to correctly work with Roadrunner, so I built and installed
> dhcpcd 1.3.17 Unfortunately, I think that dhcpcd isn't renewing my
> ip address and that's what's causing my performance problems.
> Has anyone else seen this? I scanned the mailing list archives but
> didn't find much. Any ideas?
>
> Thanks,
> Cheng
>
> ____________________________________________________________________
> Get free email and a permanent address at http://www.netaddress.com/?N=1
> ---------------------------------------------------------------------------
> Send administrative requests to [EMAIL PROTECTED]
---------------------------------------------------------------------------
Send administrative requests to [EMAIL PROTECTED]
