Hello,
When I store acquired data (export binary to raw and save the 'session' as
an sr-file), my decoders don't seem to follow. Closing pulseview and
reopening it again, the decoders aren't there? I guess I need that in order
to run sigrok-cli with the -B option? Not sure I know how to setup the
decoders otherwise...
Any suggestion how I should do to
1. import the data I want to process
2. define two decoders (select decoder and configure pins)
3. output decoder results to a file - either two separate files or one
combined file
?
An option in pulseview where one could select separate pins and decoders
for a CSV output would be great! It would also be great to have the output
only updated when selected data changes - I currently acquire 64Msamples...
I noticed two other things in the Pulseview window: when rescaling, the
view is set on the top traces regardless of where I was looking earlier. I
also notice that moving a trace is a little difficult when I go beyond the
farthest down one, seen from the top. If I grab a trace far down, the
window is immediately moved to showing the top traces and I can only drop
the trace there - I can't move it further down. In the analyser I have 32
channels, but only the top 15 (approx) are simple to view. The other ones
can of course be viewed, but I need to rescale and then move the window
down. I'm also careful not to grab these as they then drop at the top and I
can't move them down.
Many thanks in advance!
Regards,
Staffan
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
Virusfritt.
www.avast.com
<https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
<#m_3005911928444116565_DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
On Wed, Jun 27, 2018 at 8:15 AM, Soeren Apel <soe...@apelpie.net> wrote:
> Hello,
>
> > Hopefully I'm missing something obvious...
> > I have decoded some data that was captured with a logic analyzer and
> > now I would like to save only the decoded data (as seen in Pulseview)
> > to a file. Is there any simple way of doing this?
>
> Currently, no. That's still on the to-do list.
>
>
> > I have a dump of an EPROM readout and the decoder does a great job
> > turning bits into address and data. Storing that as raw binary
> > wouldn't be ideal since I would like to have the decoded data...
>
> You can use sigrok-cli for that - I have in the past, so I know it
> works. You can save the .sr file in PV and the decode using sigrok-cli.
> The -B parameter is your friend :)
>
> All the best,
> -Soeren
>
>
>
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
sigrok-devel mailing list
sigrok-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/sigrok-devel
