Sovereign Silver will test CS. http://www.natural-immunogenics.com/lab_analytical.php
- Steve N -----Original Message----- From: Ode Coyote [mailto:[email protected]] Sent: Tuesday, December 16, 2008 3:39 AM To: [email protected] Subject: Re: CS>testimony of nutronix silver ceo The first samples I ever had tested went to: North Carolina State Department of Natural Resources Water Laboratory. [Half the building is a sign the taxpayers bought] All they do is test water for the state..that's IT. They sent back an average of three runs using large samples that ranged from 45 to 55 PPM. I seriously doubt it was anything over 20 PPM They did have a spectrophotometer, but probably didn't have the right light source to test silver. I don't believe they used it. Obviously the method they did use wasn't good enough. Other samples made the same way and done by two different people [Ole Bob Berger and Frank Key ] came out at 11. something PPM with the results very close to each other. Needless to say, I never went back to the state lab. ..about $200 per sample for a complete workup at a "real" lab on a $250,000 AA Spec and a $40,000 Malvern Particle Sizer......Ole Bob charged $7 if I recall, but he was a hobbiest using an army surplus Hach colorometer that was "surprisingly" accurate. [PPM only] Ode At 11:28 AM 12/15/2008 -0500, you wrote: >Thanks, Mike. >I will give it a shot. > >Cheers, >indi > >On Thu, Dec 11, 2008 at 10:00:09PM +0000, M. G. Devour wrote: > > Hi Indi, > > > > > Do you know of any labs that have affordable rates for that sort > > > of thing? I would love to get a lab report on what I'm producing. > > > > I literally picked up the Yellow pages and found an environmental > > testing service lab a few miles from here. Dropped my samples off > > and received the report in the mail a week or two later. I don't > > remember how much it cost but it wasn't so expensive I wouldn't do > > it again, nor so cheap I'd do it all the time... <wink> > > > > > > You could have a sample tested at an environmental lab. Tell > > > > them it's silver in clean water in the low ppm range and ask > > > > what methods they have for making the measurement. Atomic > > > > absorption spectroscopy is one method I vaguely recall reading about years back. > > > > Mike D. > > > > [Mike Devour, Citizen, Patriot, Libertarian] > > [[email protected] ] > > [Speaking only for myself... ] > > > > > -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Address Off-Topic messages to: [email protected] The Silver List and Off Topic List archives are currently down... List maintainer: Mike Devour <[email protected]>
