Ode Coyote wrote:
At 12:00 AM 2/14/2009 +0005, you wrote:
Can you pre-boil your feed water for a while before putting it in the
distiller, so as to drive off any volatiles with lower boiling points?
## Sounds like a plan to me!
Or is there a way to vent the vapor for a while before you start
collecting?
Or just throw out the first bits of water collected?
## That's the general procedure, but pre-boiling sounds better to
keep that stuff out of the condenser to start with.
Separate the output into a number of different jars while the distiller
is going and see if the conductivity changes from one part of the run
to another?
## Good experiment!!
I think it is an excellent idea. However since it has not been
determined whether the contamination is of lower or higher boiling point
than water, the last should not be distilled either, the contamination
may be coming over in the last 10% instead of the first 10%.
Marshall
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: [email protected]
Address Off-Topic messages to: [email protected]
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <[email protected]>
