Afternoon Wayne, Isn't there a commandment about dropping my name in vain?...
So what's the problem? Amount of released silver, ion production, is related to current. Voltage is only relevant in that it has to be high enough to support the particular current. (Too little voltage? Move the electrodes closer together... Voltage does not change, but current will increase along with an increase of relased silver ions.) Dan On Tue, Apr 14, 2009 at 12:54 PM, Wayne Fugitt <[email protected]> wrote: > Evening Ode and Everyone, > >>> At 11:44 AM 4/14/2009, you wrote: >> >> Ion production rates are current related, not voltage related. > > Several years back, I posted a message relative to the > Current and Voltage Factor that has specific effect on > ion production. > > No one said one word, no not one. > No one agreed, no one disagreed, no one even asked a single question. > > What did this tell us, > No one knows, no one cares, no one gives a hoot, > or........... > No one knew enough to ask on question. > > Then, A year or two later, I posted the same statement again. > I think you was the very one, that agreed with me, > on maybe Dan Nave. > > The statement again, ............ >>> Ion production rates are current related, not voltage related. > > Current cannot be the same, ....... > "Without out BEING VOLTAGE RELATED" > What is Related, and What is not ? > > It remains hard for me to believe that > 3 ma does the same work at 3 VDC, 6 VDC, 12 VDC or a higher voltage. > > We were not talking about constant current devices, or regulated > circuits, They were not so common at that time. > > Of course I understand regulated circuits, voltage drops, and > resistive connections. > > One power supply that I built had 5 V Regulated, 12 V Regulated > and a 16 volt battery charger, all on the same neat little board. > > I was building solid State Voltage regulators for Cars, back into the > early 60's. Also Transistor Ignition systems that were fantastic. > One would fire a 5/8 inch gap, in a test distributor turning 7000 rpm. > That would get your attention, ...... yes it would. > > Yes, there are many voltage drops in any CS Gen circuit and the process. > Even the one across the solution changes as the batch progresses, > Regulated or NOT regulated. ( But related to something ) > > If one understand the situation at hand, they will know where these > voltage drops exist. If they do not understand, they would not understand > if I listed them. No need to add confusion, to an already confusing > situation, > > Finally, I must say, The "Resistive Connection" is the most dangerous > one of all. > > It will burn your house down and kill you. > > Anyone want to add to the confusion or Clear it all up ? > > Either way, be my guest. I will be glad to know. > > Wayne > > ================== > > > > > > > > > > > -- > The Silver List is a moderated forum for discussing Colloidal Silver. > > Instructions for unsubscribing are posted at: http://silverlist.org > > To post, address your message to: [email protected] > > Address Off-Topic messages to: [email protected] > > The Silver List and Off Topic List archives are currently down... > > List maintainer: Mike Devour <[email protected]> > >
