I produced HVAC CS for about 6 years before switching to LVDC. With my
setup I was unable to exceed more than about 7 to 8 ppm before the
particles stated becoming objectionably large, and even at 5 it produced
a yellow instead of a clear EIS. It was a real hassle, requiring a 1
1/2 ton cooling unit to keep the EIS cool enough to prevent even larger
particles.
Marshall
Richard Goodwin wrote:
I use high voltage DC, not AC. And only to kick start the process. I very
quickly reduce the voltage as the silver ions start building up, to limit
the current.
Dick
----- Original Message ----
From: sol <[email protected]>
To: [email protected]
Sent: Mon, February 22, 2010 8:49:31 PM
Subject: Ole Bob and HVAC, was Re: CS>Which layer of skin for silver
deposit?
At 06:05 PM 2/21/2010, you wrote:
Hello Dick,
It seems that this is an area that has been looked at before and there are
some theories on the quality of EIS produced at high voltages.
Unfortunately, extensive testing is cost prohibitive, so you will just
have
to go with the theory.
I think I recall that ole Bob spent quite a bit of time experimenting with
HVAC, and eventually stopped. Now that there are archives again, there may be
some info there.
Anybody else remember this, or am I confused again?
sol
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Rules and Instructions: http://www.silverlist.org
Unsubscribe:
<mailto:[email protected]?subject=unsubscribe>
Archives: http://www.mail-archive.com/[email protected]/maillist.html
Off-Topic discussions: <mailto:[email protected]>
List Owner: Mike Devour <mailto:[email protected]>
