> It will still have the same available surface Round or Flat. My comments were addressed to yours above. I'm not talking about strength, only about surface area.
Dick ________________________________ From: Tel Tofflemire <[email protected]> To: [email protected] Sent: Mon, March 8, 2010 10:56:00 AM Subject: Re: CS> Why flatten Silver wire ? Stop and think about it Dick, Weight does not change, only Density on a flattened wire or coin, may be larger but way weaker in strength. Been there Done that... My last comment on this subject ! Tel Tofflemire Dewey, AZ. ________________________________ From: Richard Goodwin <[email protected]> To: [email protected] Sent: Mon, March 8, 2010 5:34:10 AM Subject: Re: CS> Why flatten Silver wire ? Um ... don't think so. When you flatten it out (wire, coin, anything), a lot of what used to be inside (and therefore not surface), will now be on the outside (and therefore be added to the surface area). Mathematically, consider a circular cross section of wire, with, e.g., a radius of one millimeter. The area is pi sq mm, or, roughly, 3 square millimeters. The circumference, which would be the surface area, is 2*pi, or roughly 6 millimeters. Now squish it down so that instead of a circle, you have a very thin rectangle that is 30 mm long by 1/3 mm thick. The area is still 1 square millimeter, but the circumference is now 60-2/3 mm, 10 times as much surface area as before. Dick ________________________________ From: Tel Tofflemire <[email protected]> To: [email protected] Sent: Sun, March 7, 2010 2:38:24 PM Subject: Re: CS> Why flatten Silver wire ? Why flatten and weaken the silver wire? It will still have the same available surface Round or Flat. Tel Tofflemire Dewey, AZ. -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> Archives: http://www.mail-archive.com/[email protected]/maillist.html Off-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]>
