Re: CS>First Batch of CSThuja tincture soaked dressing covered with a light & waterproof tape for 6 weeks usually works & possibly Biotin will also work removing warts.
Jane ----- Original Message ----- From: Asif Nathekar To: [email protected] Sent: Sunday, March 11, 2012 6:01 AM Subject: Re: CS>First Batch of CS There are various treatments for warts which have been discussed previously including electrical based devices. Worth a look through the archives On 10 Mar 2012, at 17:26, CT <[email protected]> wrote: Thanks for the response Asif, I did, indeed, wipe the negative electrode silver clean mid-cycle. I think, all-in-all it was a pretty successful batch and I had my first “swallow” this morning. I took about 1/2 ounce shot, held it in my mouth for about 5 min and then swallowed. No immediate reactions. I have a wart on one finger that I will be watching as sort of the “test results area.” I am generally healthy however and wonder what sort of initial program dosage I should go on. I was planning on 1 ounce daily (1/2 morn and 1/2 night). Any thoughts or suggestions on this? Thanks again to all, CT I would decant into the final vessel and stop just before the sludge starts pouring out. I do not believe the floaters at the top should be a problem Also make sure you wipe and clean your electrodes even mid cycle so that the sludge is at a minimum If you're excessively creating sludge then you may wish to lower your current a bit. I would go no higher than 1ma per square inch squared maximum. For example I brew with a 6 inch squared surface area and I brew at 2.5 ma roughly with constant current control. And it doesn't turn yellow, however whenever I approach 1ma per square inch squared then the liquid will colour slightly towards amber. Sent from my iPhone On 10 Mar 2012, at 15:43, "CT" <[email protected]> wrote: First Batch of CS Hello all, I just made my first batch of CS. I think it came out pretty good, but now I am left with a quandary: I have some thick silvery sludge at the bottom of my jar and some smaller flakey silver floating on top of the CS liquid. I don’t have any “approved” filtration method in place and I would like to decant the liquid, however I am tempted to paper-towel the top of the liquid to remove the flakey pieces. I think I can decant without getting any of the bottom sludge into the new container. Any advice would be very appreciated. Thanks, Chris Thomas No virus found in this message. Checked by AVG - www.avg.com Version: 2012.0.1913 / Virus Database: 2114/4862 - Release Date: 03/10/12
