I've read many e-mails on this forum about achieved ppm, but little on
how the parties accomplished and confirmed their results. It would be nice
to create a data base of methods in order to create a standard.
I have seen a couple of e-mails which addressed using a volt-ohm-meter
to read ppm.
Example: 4usec/cm = 1/250kohms; this measurement appears to be achieved
by placing the VOM probes in the CS solution at a spacing of 1cm.
Example2: 1ppm = 1.6usec/cm (+/- 20%); If both examples are correct then
5ppm would be equal to 5ppm X 1.6usec/cm = 8usec/cm
8usec/cm = 1/R = 125kohms resistance between the VOM probes which are
spaced 1cm apart in the CS solution.
If we can gather data from known ppm solutions using the above method ,a
rough standard could be established and everyone would know about what
strength of CS solution they have produced.
Resistance measurements of 5ppm, 10ppm, 20ppm, and 30ppm should give a
well rounded data base.
I realize that their are many other factors to consider when trying to
measure ppm. The purpose of this e-mail is to try and establish a standard
by which everyone can use without purchasing some expensive high tech
device.
If a simple standard has already been established, what is it?
I would like to know if anyone has a recipe for making colloidal silver
salve.
Thank you,
BillH
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
List maintainer: Mike Devour <[email protected]>