I thought the Silver Puppy shut down automatically when the ppm hits
about 10 ppm ? What would cause the Silver Puppy to produce 26-30 ppm
when set to Auto & SWAP?
On 12/15/2013 2:32 PM, JD wrote:
I made a batch of CS with my Silver Puppy and it had a slight
yellow tint to it (usually is clear),
Yellow normally means that your ppm is too high.
so I added a little Hydrogen Peroxide to it and it turned
cloudy. What does this mean?
It means that the ppm is over 26 ppm, so it has exceeded the
solubility limit for the silver oxide.
I thought adding a little H2O2 is suppose to turn yellow to clear.
It does, if the ppm is below 26 to 30 ppm. Often if you wait 48
hours it will still clear, as some of the ionic converts to
colloidal, making room for the precipitated silver oxide to redissolve.
Marshall
