Kent,  More.
-- 
oozing on the muggy shore of the gulf coast
  [email protected]
--- Begin Message ---
-----Original Message-----
From: Tai-Pan <[email protected]>
To: [email protected] <[email protected]>
Date: Saturday, 24 April 1999 09:01
Subject: CS>555 Timers, I limiters,


Excellent post Bob,

I use a LM-317, in this very arrangement, in my small generators.
Found it on the web as a cheap and easy NiCad battery charger.
I found I needed a 10K ohm pot (I use a trimmer) in my application,
adjusted to supply 0.5mA under full load.
>
> A very easy to make adjustable current limiter can be made with only
>two parts. An LM-317 three terminal regulator and a 250 ohm
>potentiometer will do it. These are availible at any electronics
place
>at low cost, typically about $2.50 for the LM-317 and about $2.00 for
>the petentiometer.
>  The three terminals are Vin, Vout, and Adj. The Vin terminal
connects
>to the power source, the Vout terminal goes to one end of the
>potentiometer,the Adj terminal goes to the other end of the
>potentiometer. (a potentiometer is a resistance element with a wiper
>that moves over the resistence element, it has three terminals).
>  The end of the potentiometer that has the Adj wire attached to it
goes
>to the silver electrodes (the load). The center potentiometer
terminal
>(the wiper terminal) is connected to the Vout terminal. This mades
the
>potentiometer into the same thing as a rheostat ( a two connection
>variable resister). To use it, place an milliamp meter in the cicuit
and
>adjust the *pot*(slang for potentiometer) for the current you want,
and
>thats where the current will stay. Of course there has to be current
>flowing to start with, so wait until you have a good current flow
before
>you set it for what you want. The LM-117 can be used in place of the
>LM-317. This is a little known use of the three terminal regulator.

<snip>
>  Bless you  Bob  Lee


Ivan


--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>



--- End Message ---