On Fri, 19 Nov 1999 12:35:29 -0700, "Katarina Wittich" <[email protected]>
wrote:
>Now what do you mean when you say ">
>> If you place it on the milliamp range, in series with one of your silver
>> electrodes, you will know the current going through your water.
>I have the bob beck silver pulser and the electrodes are not detacheable --
>does in series mean I would have to put the meter between the electrode and
>the wire that leads to it? I guess I could dismantle it and figure out how
>to reattatch. Suggestions?
My comments referred to adding a milliamp meter to the simplest of setups.
That is: 3 battery, 2 clipleads, 2 silver electrodes that are bent to clip on
the edge of a glass of distilled water.
Anything else will take some simple innovation.
If your device is complete with silver electrodes attached, you'll have to
leave your device on the bench and use seperate new silver as above.
Run one clip lead from the meter to one of the electrodes on the Beck device.
Run one cliplead from the other meter terminal to a new silver electrode on the
glass.
Run a third cliplead from the other Beck electrode to the other silver
electrode on the glass.
Set the meter to read current, or milliamps (depend on your meter).
If you draw it out, it's pretty simple.
Chuck
if you think education is expensive -- try ignorance.
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>