More
--
oozing on the muggy shore of the gulf coast
[email protected]
--- Begin Message ---
[email protected] wrote:
>
> Bob,
>
> My TDS-1 seems to work fine with DC CS however when i use my HVAC CS maker
> (Motherlode) it seems to read way too high. Making the HVAC CS according
> to specs I should only be reading 8-10 ppm but I am reading 63 - 68 PPM,
> also the ph goes from 7 when I start to 3.5 at the end. With DC I end up
> reading 8 - 12 PPM and there is no change in the ph, it stays at 7.
>
> Any ideas?
>
> thanks,
> Bill
Hi Bill and list,
This is very interesting. You have indicated that everything is OK
using DC, normal ppm and pH. Then you say its abnormal using AC(HVAC),
with hi ppm and pH close to vinegar. I can understand the hi ppm ,caused
by large particles of silver(larger than 100mu ,milli-microns)or
1 X 10-4mm for you metric types. It makes the ppm look impressive, but
only ions and small molecules,smaller than 4mu, milli-microns, (4 X 10-6
mm) can pass the body membranes and cell membranes.Thats a large rock
compared to a grain of sand. Even with the large particles there will be
smaller pieces which are useful. Ions and small molecules are always
produced with the larger particles.
About the pH however , its not very clear what the cause could be.
Something is there that should not be there, a contaminate of some kind.
Pure water and pure silver will not give much of a pH change. I find my
CS is slightly base (alkaline) at 6.8 pH after making it.
Check your water,your air,your container. Are you getting an electric
arc ? Lots of by-products from electric arcs.Note on electric arcs: We
do not allow an arc when making ozone(O3).We use a silent discharge to
prevent unwanted by-products from forming.
Don`t know if you take TDS-1 readings with the power on or off,don`t do
it with power on.
Maybe someone else has an insight to this or useful viewpoint.
No body has all the answers, thats why we are here on this list ,to
learn from others.
Bless you Bob Lee
--
oozing on the muggy shore of the gulf coast
[email protected]
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the subject: line.
To post, address your message to: [email protected]
List maintainer: Mike Devour <[email protected]>
--- End Message ---
