Hello Bill,
Lavender is the color you usually get when using mineralized water, which
apparently is what you're using. Other colors also show up with minerals
in the water. It is best to use distilled water. If you can't get it,
maybe you'll have to make your own. Without pure water, you won't make
what is considered good CS. The best CS is clear, not yellow as I used to
think. However yellow is still OK. I would toss any other color out or
use it externally.
Rainwater would have less mineralization than water that has touched the
earth. If you do catch it, do so out in the open, not water that has run
off the roof. Roofs are notoriously dirty.
Trem
www.silvergen.com
At 05:09 PM 5/28/00 +0100, you wrote:
Hi Folks,
I'm new to the list.
I've been making CS (Huh!) for the past six months, but have not yet
succeeded in obtaining the yellow color so many folks write about. It ranges
from transparent to pale lavender, but not yellow. The wire is .9999, the
generator(s) range from one PP3 to four x PP3 (different models). I time it
from 4 mins up to 30 mins depending on which generator I use. Only thing I
have not got is distilled water. Purified yes, Spring water, tap water,
injectible water, distilled no. Is rainwater any good? We got plenty of
that. Where am I going wrong?
I'm in the UK.
Bill C.
--
The silver-list is a moderated forum for discussion of colloidal silver.
To join or quit silver-list or silver-digest send an e-mail message to:
[email protected] -or- [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
